![]() ![]() The best is to test it with different settings until you get the wave 100%. Traductions en contexte de 'générateurs de houle' en français-anglais avec Reverso Context : Il comprend également des générateurs de houle, de vent et de courants. If I lower the water level of my tank with about 5 cm I get a perfect wave, but then the water level is to low. The compact sizeallows discrete mounting in the corner of the aquarium. The hight of the water also have an impact on the wave. The TUNZE Comline Wavebox 6214 is a wave generator for aquariums from 400 to 1,400 liters (105 to 370 USgal.), depending on the type of the aquarium and on the decoration. This timing is basically the time the wave take to move from the one side of the tank to the other side and back. If you look in the Tunze handbook for the wavebox, the settings change from 0.83s for a tank of (l) 150 cm x (w) 100cm x (h) 60cm to 0.86s for a tank of (l) 180 cm x 100cm x 60cm. The Wavebox’s dimensions are: Length: 125mm x Width: 113mm x Depth: 300mm (4. tunze recommends it for aquaria sized from150 to 1,500 liters (39 to 396 US gallons). It is rather large and intrusive in all but the largest aquarium. My settings is currently on 1.5s min and 1.5 sec max, but it's not going to work in your case. The Wavebox is simply a rectangular container that houses the pump and collects water to be pumped. Can how does the Wavebox connect to the Profilux - does the Tunze cable go from the L1L2 port direct to the wavebox driver or via the slave socket on the wavebox controller? Thanks, Andy I asked un Ultimate Reef about the benfit of controlling the Wavebox via the Profilux, but the response seemed to be use it's own controller. Hi, I'm interested in this too as I have just got the same wavebox and my tank is a similar size - 1300 L x 850 W x 700 D but I haven't set this up yet.
0 Comments
Leave a Reply. |